<p>My homerun arrived today, but I can't seem to use it to tune to any channels. Ok, so hdhomerun_config finds the device. I follow the directions on the Mythbuntu site (which was recommended off of Silicon's site as well as <a href="http://wiki.mythtv.org">wiki.mythtv.org</a>). When I do the channel scan I either get "no signal" or "no table". No channels are added to the lineup. I tried googling, but everyone has problems finding the Homerun. I can already find it - so I know that's not an issue. And the fact that mythtv scans and on some of them finds "no table" make me feel that MythTV can "see" the HD Homerun. Now, I know the antenna is good because I hooked it up to my Insignia converter box and then to my TV and I was able to access 12 channels. The TV is in the same room as the HD Homerun and only a few feet away. If I run hdhomerun_config ID scan 0, none of the channels lock. I am using the Terk TV 4 as my antenna, but again, it works on my Insignia - so it should work with HD Homerun, right? I do not have it hooked up via a splitter - it is hooked up directly to the HD Homerun.</p>
<p></p><p>Thanks,<br clear="all"></p><br>-- <br>Eric Mesa<br><a href="http://www.ericsbinaryworld.com">http://www.ericsbinaryworld.com</a><br>