I'm trying to get Myth working on an older system (P4 1.7 GHz, Hauppage
WinTV Go tuner card connected via minijack to SB Live value card,
GeForce3 video card) so that I would have a convenient way of recording
TV shows - I'm not all that concerned about audio or video quality.  I
installed it using the Mythdora distro, and everything seems to be
working fine save audio.  I've hit a snag because I can't figure out
why my video lags behind my audio - sometimes it's by several
seconds... sometimes it's only off by seemingly less than a second. 
Also, after I exit "Watch TV" mode, I still get the sound from whatever
channel I had been on and it continues to stay on even after exiting
the frontend until I open another program that makes use of the tuner
card.  After I close that second program, the audio stays off.  I have
the line in muted, but set to record.  After playing with mixer
settings, I found the sound coming from the TV tuner only goes away
after setting PCM to mute.
<br><br>The fact the gap between audio and video never seems to be the
same made me think that the computer was just too slow and that video
encoding just couldn&#39;t keep up, but then the fact that sound stayed on
after exiting the frontend made me think the sound is not setup
correctly, either in Myth or elsewhere.&nbsp; Is the first scenario even
possible?&nbsp; As for the second scenario, everywhere I&#39;ve searched says
make sure the line in is muted, and I&#39;ve already ruled that out.
<br><br>Any ideas for fixes, or things to check would be greatly appreciated.&nbsp; I&#39;m at a loss as to where to go at this point.