<b><i>Axel Thimm <Axel.Thimm@ATrpms.net></i></b> wrote:<blockquote class="replbq" style="border-left: 2px solid rgb(16, 16, 255); margin-left: 5px; padding-left: 5px;"><Axel.Thimm@ATrpms.net>Then let me introduce you to google:<br><br>http://www.google.com/search?q=atrpms+lirc+blaster<br><br>...<br><br>There seem to be more than one guide for setting up IR blasters with<br>ATrpms support. In fact even the first 10 hits from google contain 3<br>such guides ...<br>-- <br>Axel.Thimm at ATrpms.net</Axel.Thimm@ATrpms.net></blockquote>Axel,<br><br>The first hit, which was also suggested by Nick, fails--it is the guide I was going off of previously (before trying the more complicated ones).<br><br>Installation and setup according to the guides proceeds with no error messages (this is after a fresh install of myth following Jarod's guide). When I attempt to manipulate the set-top box using the following,<br><br>irsend --device=/dev/lircd1 SEND_ONCE DCT2000
012<br><br>...I get the following errors<br><br>irsend: could not connect to socket<br>irsend: Connection refused<br><br>According to the irsend man page, this is because either lircd is running or /dev/lircd does not have write permissions. Neither of these is true:<br><br>lircd (pid 2134) is running...<br>srw-rw-rw- 1 root root 0 Oct 3 19:22 /dev/lircd<br><br>dmesg says:<br>lirc_dev: IR Remote Control driver registered, at major 61<br>lirc_serial: auto-detected active high receiver<br>lirc_dev: lirc_register_plugin: sample_rate: 0<br><br>...so I think lirc is running properly. Not sure what the problem is. /dev/lirc0 exists. So far as I can tell, everything is good to go, except irsend won't work.<br><br>Any ideas? I have tried putting the IR blaster on either serial port, and switched the settings in modprobe.conf from COM1 (/dev/ttys0) to COM2 (/dev/ttsy1), neither helped.<br><br>Regards,<br>Pete<br><p> 
<hr size=1>Get your email and more, right on the <a href="http://us.rd.yahoo.com/evt=42973/*http://www.yahoo.com/preview"> new Yahoo.com</a>