Hi there.<br>
<br>
Installing Mythtv with a PVR-350 on FC4. Have gotten X to display on my
tv, but I am left with the overscan problem, i.e. I can not see the
entire desktop on my tv, which is frustrating.<br>
<br>
When I try to run mythtv-setup, I can not see the entire screen either, the edges are cut off.<br>
<br>
Have googled and looked at various forums, but no luck so far. Have
used xvidtune to try and tweak the settings, but have not been able to
find a good match.<br>
<br>
This is the section on my xorg.conf file:<br>
<br>
Section &quot;Monitor&quot;<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Identifier &quot;PAL Monitor&quot;<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; HorizSync 30-68<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; VertRefresh 50-120<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Mode &quot;720x576&quot;<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; DotClock 42.6<br>
 &nbsp;&nbsp; &nbsp;&nbsp;&nbsp;&nbsp; HTimings 720 760 832 944<br>
&nbsp; &nbsp;&nbsp;&nbsp;&nbsp;&nbsp; VTimings 576 577 580 602<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Flags &quot;-HSync&quot; &quot;-VSync&quot;<br>
&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; EndMode<br>
EndSection<br>
<br>
Any thoughts on how to get this to display properly?<br>
<br>
Thanks in advance.<br>
<br>
Niklas<br>
----------<br>