<P>I have been reading the forums for awhile and finally made a purchase of a PVR-350. I have googled and tried different config combos. Can't seem to get it working.</P>
<P>I'm not too sure what goes into the modules.conf, modprobe.conf or what can be done my command line instead. I have seen multiple examples...</P>
<P>I haven't seen anything useful on the S-Video output but snow (zebra colors) etc. Haven't tried the RCA<BR><BR>Any suggestions or insight would be greatly appreicated. </P>
<P>Steve</P>
<P><BR>Following is some information:</P>
<P># dmesg | grep tveeprom<BR>tveeprom: Hauppauge: model = 48132, rev = K268, serial# = xxxxxxxx<BR>tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47)<BR>tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)<BR>tveeprom: audio_processor = MSP3440 (type = 11)<BR>------------- done ------------<BR><BR># cat /etc/modules.conf<BR># This is for WinTV PVR-350 IVTV<BR>alias char-major-61 lirc_i2c<BR>alias char-major-81 videodev<BR>alias char-major-81-0 ivtv<BR>alias char-major-81-1 bttv</P>
<P>options ivtv ivtv_debug=1<BR>options tuner type=47<BR>options saa7127 enable_output=1 output_select=1<BR>options msp3400 once=1 simple=1<BR>add below ivtv msp3400 saa7115 saa7127 tuner<BR>add above ivtv lirc_dev lirc_i2c ivtv-fb<BR>post-install ivtv /usr/bin/ivtvctl -d /dev/video0 -u 0x3000<BR>------------- done ------------<BR><BR># cat /etc/modprobe.conf<BR>install snd-emu10k1 /sbin/modprobe --ignore-install snd-emu10k1 && /usr/sbin/alsactl restore >/dev/null 2>&1 || :<BR>alias usb-controller uhci-hcd<BR>alias snd-card-0 snd-ens1371<BR>options snd-card-0 index=0<BR>install snd-ens1371 /sbin/modprobe --ignore-install snd-ens1371 && /usr/sbin/alsactl restore >/dev/null 2>&1 || :<BR>remove snd-ens1371 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-ens1371<BR>------------- done ------------<BR><BR># modprobe ivtv<BR>(Output from dmesg)</P>
<P>ivtv: ==================== START INIT IVTV ====================<BR>ivtv: version 0.2.0 (rc3j) loading<BR>ivtv: Linux version: 2.6.11-1.27_FC3 686 REGPARM 4KSTACKS gcc-3.4<BR>ivtv: In case of problems please include the debug info<BR>ivtv: between the START INIT IVTV and END INIT IVTV lines when<BR>ivtv: mailing the ivtv-devel mailinglist.<BR>ivtv: Autodetected WinTV PVR 350 card<BR>ivtv: Found an iTVC15 based chip<BR>PCI: Found IRQ 5 for device 0000:00:11.0<BR>PCI: Sharing IRQ 5 with 0000:00:0d.0<BR>ivtv: XXX PCI device: 0x7190 vendor: 0x8086<BR>ivtv: i2c attach [client=tveeprom,ok]<BR>tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 7875964<BR>tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47)<BR>tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)<BR>tveeprom: audio_processor = MSP3440 (type = 11)<BR>ivtv: Tuner Type 47, Tuner formats 0x00001000, Radio: yes, Model 0x00ad2598, Revision 0xd4a85433<BR>ivtv: NTSC tuner detected<BR>ivtv: Radio
detected<BR>tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0<BR>ivtv: i2c attach [client=(tuner unset),ok]<BR>saa7115: starting probe for adapter SMBus PIIX4 adapter at 7000 (0x0)<BR>saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005)<BR>saa7115: detecting saa7115 client on address 0x42<BR>saa7115: writing init values<BR>ivtv: i2c attach [client=saa7115[0],ok]<BR>saa7115: status: (1E) 0x48, (1F) 0xc0<BR>saa7127: Ignoring new-style parameters in presence of obsolete ones<BR>saa7127: video encoder driver version V 0.3 loaded<BR>saa7127: detecting saa7127 client on address 0x88<BR>saa7127: Selecting NTSC video Standard<BR>saa7127: Selecting S-Video+Composite<BR>saa7127: Turn WSS off<BR>saa7127: Widescreen Mode 4:3 Full Format<BR>saa7127: Selecting Normal Encoder Input<BR>saa7127: Enable Video Output<BR>ivtv: i2c attach [client=saa7127[0],ok]<BR>msp34xx: init: chip=MSP3448W-A2 +nicam +simple +simpler +radio mode=simple<BR>msp3410: daemon started<BR>ivtv: i2c attach
[client=MSP3448W-A2,ok]<BR>ivtv: Encoder revision: 0x02040024<BR>ivtv: Encoder Firmware may be buggy, use version 0x02040011<BR>ivtv: Decoder revision: 0x02020023<BR>ivtv: Configuring WinTV PVR 350 card with 9 streams<BR>ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total<BR>ivtv: Registered v4l2 device, streamtype 0 minor 0<BR>ivtv: Create DMA stream 1 <BR>ivtv: Registered v4l2 device, streamtype 1 minor 32<BR>ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total<BR>ivtv: Registered v4l2 device, streamtype 2 minor 224<BR>ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total<BR>ivtv: Registered v4l2 device, streamtype 3 minor 24<BR>ivtv: Create stream 4 <BR>ivtv: Registered v4l2 device, streamtype 4 minor 64<BR>ivtv: Create DMA stream 5 using 16 65536 byte buffers 1048576 kbytes total<BR>ivtv: Registered v4l2 device, streamtype 5 minor 16<BR>ivtv: Create stream 6 using 1024 2048 byte buffers
262144 kbytes total<BR>ivtv: Registered v4l2 device, streamtype 6 minor 228<BR>ivtv: Create stream 7 <BR>ivtv: Registered v4l2 device, streamtype 7 minor 232<BR>ivtv: Create DMA stream 8 <BR>ivtv: Registered v4l2 device, streamtype 8 minor 48<BR>ivtv: Setting Tuner 47<BR>tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0<BR>saa7115: decoder set input (4)<BR>saa7115: now setting Composite input<BR>ivtv: Setting audio matrix to input 3, output 1<BR>ivtv: Switching standard to NTSC.<BR>spurious 8259A interrupt: IRQ7.<BR>saa7115: decoder set norm NTSC<BR>ivtv: ivtv_enc_thread: pid = 4234, itv = 0xd4a7a0a0<BR>ivtv: ivtv_dec_thread: pid = 4235, itv = 0xd4a7a0a0<BR>saa7115: set audio: 0x01<BR>saa7127: Setting Encoder Video Standard<BR>saa7127: Set NTSC Video Mode<BR>saa7127: Selecting NTSC video Standard<BR>ivtv: Initialized WinTV PVR 350, card #0<BR>ivtv: ==================== END INIT IVTV ====================<BR><BR># modprobe ivtv_fb<BR>(dmesg
output)<BR>ivtv-osd: Framebuffer module loaded (attached to ivtv card id 0)<BR>ivtv-osd: Framebuffer is at decoder-relative address 0x00510000 and has 1704960 bytes.<BR>ivtv-osd: screen coords: [0 0] -> [720 480]<BR>ivtv-osd: original global alpha = 208<BR>ivtv-osd: current OSD state = 39<BR>ivtv-osd: new global alpha = 208 (1 255 0)<BR>ivtv-osd: framebuffer at 0xe9510000, mapped to 0xd5910000, size 1350k<BR>ivtv-osd: mode is 720x480x32, linelength=2880<BR>Console: switching to colour frame buffer device 90x30<BR>ivtv-osd: fb0: iTVC15 TV out frame buffer device<BR>------------- done ------------<BR></P><p>
<hr size=1>Yahoo! Mail<br>
Stay connected, organized, and protected. <a href="http://tour.mail.yahoo.com/mailtour.html">Take the tour</a>