[mythtv-users] Stereo sound on WinTV 2000XP Deluxe?
Bernard Mentink
ebike at paradise.net.nz
Fri Feb 27 19:27:47 EST 2004
Hi There,
I have btaudio running fine with by 2000XP Delux.
I have to use the "analog" device though with mythtv, not the "digital".
I.E: digital = /dev/dsp1 analog = /dev/dsp2
I'm not sure if it is running in stereo though, as I am using a small
flatscreen
monitor to set things up. I did remember passing GPIO parameters to bttv
to enable all the GPIO's
maybe this turned sterio on for me.
Even though mythTV cannot use the digital channel, sox seems to be able to
use it.
Cheers,
Bernard Mentink
On Fri, 27 Feb 2004 10:10:28 +0100, Niklas Brunlid <nbr at ticalc.org> wrote:
> I understand that the Wintv 2000XP Deluxe supports NICAM stereo, or at
> least old plain stereo. But when I check with v4lctl the "audio mode"
> parameter is stuck on "lang1", and I can't change it. It also "feels
> like"
> the audio I'm getting is mono, as well as slightly distrorted (as in,
> sound like <44.1kHz). Where do I configure this?
>
> ALso, am I right in assuming that btaudio support for this card is a
> no-go, even though the snd_bt87x module loads fine and lspci shows the
> bt878 device as a capture source?
>
> / Niklas
More information about the mythtv-users
mailing list